Microscan HE40T Manuel d'utilisateur télécharger pdf (Page 20)

Chapter 1 Getting Started

1-10 HawkEye™ 40T User Manual Rev 2.0.0, Jan 2009

• Transfer Only Unsent Data in Memory — This code will send only the data

in memory that hasn’t already been sent when the code is scanned (ONLY

works in Send and Log mode).

• Delete Scanned Data from Memory — Scanning this code will erase all data

in the reader’s non-volatile memory.

You may also program a trigger to transfer data (see Chapter 2, “Optimization

and Trigger Programming”).

Auto Transfer Buffer Memory

By default, when reconnected, the HE40T will automatically transfer any data in

memory once a connection to a host is established. If your application is not

ready, the reader will send the data anyway and the data could be lost. If you do

not wish for the reader to immediately send data upon connection, scan the

Disable Auto Transfer Buffer Memory, as shown in Figure 1–9.

FIGURE 1–9. Auto Transfer Buffer Memory Codes

Send & Buffer

Mode (Default)

Log Only Mode

Send & Log Mode

Transfer All Data

Enable Auto Transfer

Buffer Memory (Default)

Transfer Only Unsent

Data in Memory

Delete Scanned Data

from Memory

Disable Auto Transfer

Buffer Memory

in Memory

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 93 94

Pas de commentaire

Microscan HE40T Manuel d'utilisateur Page 20