Microscan MS-4X Manuel d'utilisateur télécharger pdf (Page 16)

1-8 MS-Connect 210 User’s Manual

Connect the System

Connecting the MS-Connect 210 to a Host

Once you have a reader connected to the MS-Connect 210 by RS-232, you have the

option of connecting the MS-Connect 210 to a host computer.

1. Unscrew one of the three CGB caps at the back of the unit.

2. Clear the CGB’s access hole to create a cabling route

into the box.

Pass a pre-stripped RS-232 Host Cable (P/N 61-000105-01)

through the access hole so that the 9-pin connector is

outside the box, and the end to be wired is inside the box.

4. Wire the Host Cable to the “Host RS-232” terminal block (J13).

5. Connect the Host Cable to the host’s RS-232 port.

Host Cable (61-000105-01)

•Wire RX232 to Host Transmit, Pin 3

•Wire SGNL GND to Host Ground, Pin 5

•Wire TX232 to Host Receive, Pin 2

•Wire CHASSIS to Host Cable Shield Wire

Connection ID label

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Pas de commentaire

Microscan MS-4X Manuel d'utilisateur Page 16