Microscan MS-4X Manuel d'utilisateur télécharger pdf (Page 171)

Chapter 11 Matchcode

MS-880 Industrial Long Range Scanner User’s Manual 11-9

11–Matchcode

Sequence On Mismatch

Note: Matchcode must be set to Sequential for this command to function.

The scanner will sequence the master to one more/less than the decoded symbol. As

an example of Sequence On Mismatch Enabled, consider the following decodes:

As an example of Sequence On Mismatch Disabled, consider the following

decodes:

Definition: When set to Enabled, the master label sequences on every decode,

match or mismatch.

When set to Disabled, the master label will not sequence whenever

consecutive mismatches occur.

Usage: Enable this parameter if every trigger event should have a decode and

more than one consecutive mismatch may occur.

Disable this parameter if every trigger event should have a decode but

no more than one consecutive mismatch may occur.

Serial Cmd: <K223,matchcode type,sequential matching,match start position,

match length,wild card character,sequence on noread,sequence on

mismatch>

Default: Disabled

Options: 0 = Disabled, 1 = Enabled

Master label Decoded label Master label after decode

001 001 002

002 002 003

003 abc 004 (sequenced on mismatch)

004 004 005

005 def 006 (sequenced on mismatch)

006 ghi 007 (sequenced on mismatch)

007 007 008

Master label Decoded label Master label after decode

001 001 002

002 002 003

003 abc 004 (sequenced because of previous match)

004 004 005

005 def 006 (sequenced because of previous match)

006 ghi 006 (not sequenced because of previous mismatch)

006 006 007

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 311 312

Pas de commentaire

Microscan MS-4X Manuel d'utilisateur Page 171