Microscan MS-4X Manuel d'utilisateur télécharger pdf (Page 198)

Insertion Mode

13-8 MS-880 Industrial Long Range Scanner User’s Manual

13–Output Format

Insertion by Serial Command

Output #

Length

Hex String

Output Format Examples by Serial Commands

A label with the data ABCDEFGH needs to be manipulated to output:

DEFGH@$ABCend.

The following commands are sent to achieve this setup:

<K740,1,4,5> for extraction mode, output# =1, start position = 4, length = 5.

<K741,2,2,4024> for extraction mode, output# = 2, start position = 4, length = 5.

Note that the hex pairs 40 and 24 = @$ in ASCII.

<K740,3,,3> for extraction mode, output# = 3, start position = 4, length = 5.

<K741,4,3,656e64> Note that 656e64 = “end”.

<K741,0> This ends the sequence and could have been done with a 740 command,

as well.

Definition: An Output # identifies the step involved in an output format process.

For example, if the Output Format routine involved a series of four

Extraction and/or Insertion steps, each of these steps is controlled by

assigning sequential output numbers from 1 to 4.

Serial Cmd: <K741,output #,length,hex string>

Default: (none) Must be entered.

Options: 1 to 100

Definition: Specifies the length of the output string.

Serial Cmd: <K741,output #,length,hex string>

Default: 0 (A zero disables Length or can mark the end of a format cell array.)

Options: 0 to 4

Definition: A pair of hex digits represent an ASCII character. Each pair of hex digits

ranges from 00 to FF. Each hex string has a maximum of 4 pairs.

For example, hex 65 = ‘e’, 6e = ‘n’, 64 = ‘d’, thus 656e64 = “end”

Serial Cmd: <K741,output #,length,hex string>

Default: 00

Options: 00 to FF

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 311 312

Pas de commentaire

Microscan MS-4X Manuel d'utilisateur Page 198